wxGUI vector display forgets layer selection

[mmetz]

When opening properties dialog again, the previously selected layer number in the selection tab gets replaced by 1 in devbr6 and by blank in trunk. Other options are remembered. Layer number 1 behaves like -1 in devbr6, all features are displayed, not only features in layer 1. Works fine in 6.4.0RC4, apart from that layer 1 can be selected even if layer 1 has no features, but then nothing is displayed (correct in this case).

I used the test vector file of ticket #577 with no features in layer 1, 1 line in layer 3 and 4 points in layer 5.

Markus M

[cmbarton]

When I open and then reopen the properties dialog for a vector the layer number does not change. Maybe I don't quite understand the issue here. I'm looking at this in the current (21 Sept 2009) version of devbr6 svn.

Michael

[mmetz]

Replying to cmbarton:

When I open and then reopen the properties dialog for a vector the layer number does not change. Maybe I don't quite understand the issue here. I'm looking at this in the current (21 Sept 2009) version of devbr6 svn.

Hmm, maybe this is a problem of my system? Using current versions of relbr6 and devbr6 (22 Sept 2009), the layer number still switches back to 1 after a split second if I selected layer 3 or 5 previously. The display however still shows the correct selection for the previously selected layer, that only changes after I manually change the layer number.

Markus M

[martinl]

No activity last 7 years, closing, feel free to reopen if needed.