better handling to change snapping options

[gespiel]

While digitzing, it´s often necessary to change snapping options. Working with a lot of vektor layers and near situated vertexes and segments, it is difficult to snap the wished segments or vertexes. To get good results, it ist necessary to activate or deactivate a layer in the popup window of the snapping options when digitizing with snapping from different layers. At the moment, it is complicate to change the snapping options by the menue in QGIS.

Is it possible to get the snapping otion window with an icon in the toolbar to change the settings?

[pcav]

If I understood your suggestion, this is now implemented in trunk. Please reopen if not.

[gespiel]

Hi,

thanks for your work. I have installed trunk r15328 (trunk nr. 81). My suggestion is to optimize catching function. In the attached examples, i want to digitize a new polygon in the layer "testpolygoncadfunctions". I catch from the vertexes from the layer "Flurstuecke" The problem is, that normaly, I do not see the vertexes of the layer "Flurstuecke" (see attached picture 1). The result of the digitzed polygon is not precise.

I only see the vertexes of the layer "Flurstuecke", when I set the layer "Flurstuecke" in the edit mode. That is not good, because I dont want edit the layer "Flurstuecke". Therfore, i proposed, to add in the window "catching options" a chekbox to see the vertexes of the layer, you catch from, in my example, I want to see the vertexes of the layer "Flurstuecke".

[pcav]

You can see them if you set the other alyer as editable. If this solves for you, please close this ticket.

[gespiel]

Sorry,

the problem of this ticket is solved since ver 1.7 begins. It was my mistake to reopen this ticket and so, I close it.

The problem I mentioned in change history is reported in ticket 3291.

Gerhard